TECHNICAL BULLETIN INDEX Sorted by Bulletin Number 06/25/86 No. Catalog Description Rev. Date =============================================================================== 16:001 26-6002 Cabling for FDC alignment and jumpering of board. 05/13/82 16:002 26-6002 Installing Bisync. 05/13/S3 16:003 26-6002 Intermittent operation of the Z80 CPU board. 05/13/83 16:006 26-6002 Checksums for Model 11/16 boot ROM. 01/24/84 16:005 26-6002 C41 installed backwards on early Rev. D CPU boards 05/13/83 16:006 26-6002 Proper jumpering for 2 internal drives. 05/13/83 16:007 26-6002 Adjusting bead load arm and disk ejector trigger. 05/19/83 16:008 26-6002 Modification to correct motor speed variation. 05/16/83 16:009 26-6002 Correct drive termination. 05/19/83 16:010 26-6002 Check for correct fusing of 24 volts. 05/16/83 16:011 26-6167 Additional hardware necessary for Model 12 and 16. 05/25/83 16:012 26-6002 Schematics for Zenith and Motorola video boards. 10/07/82 16:013 26-6002 Intermittent speed errors on Tandon drives. 10/18/82 16:016 26-6002 Slippage of the stepper band assembly. 02/02/83 16:015 26-6002 Increasing the +5 volt power supply. 09/04/86 16:016 26-6002 Installation of Mu1ti-terminal brd. in Model 16. 05/28/85 16:017 26-6002 Schematic corrections on KeyTronic keyboard. 06/26/84 16:018 26-6002 Memory buffer problems on 68K RAM boards. 08/27/84 16:019 26-6016 Insure good ground between 68K CPU and RAM brds. 01/16/85 16:020 26-6016 Correct timing to memory board during write cycle. 02/13/85 16:021 26-6014 Outline 8 MHz upgrade procedure. 03/19/85 16:022 26-6002 An error in the installation of R87. 05/29/85 16:023 26-6002 Modification for Xenix 3.0 on a 6 Mhz CPU board. 07/11/85 16:026 26-6002 Modifications to increase reliability. 07/22/85 16:025 26-6001 To allow use of Disk Cartridge System. 01/16/86